Skip to content
Points Unknown – Tech Blog

Points Unknown – Tech Blog

Technology, Gadgets, Home Automation, 3D Printing, Photography, Productivity

Technology, Gadgets, Home Automation, 3D Printing, Photography, Productivity

  • Software
  • Photography
  • 3D Printing
  • Gadgets
  • Home Automation
  • Productivity
  • Linux

Ender 3

3D Printing Uncategorized 

3D Print Settings for ABS on Ender 3

August 12, 2022August 12, 2022 Austin 0 Comments 3D Printing, ABS, Ender 3

Even with a hand made enclosure around my Ender 3 I was still struggling to get ABS to 3D print

Read more
3D Printing 

3D Print Settings for PETG on Ender 3

June 6, 2022August 12, 2022 Austin 0 Comments 3D Printing, Ender 3, PETG

These are my settings for PETG in Ultimaker Cura for my Ender 3 Generally 230 to 240 degrees nozzle Hot

Read more
3D Printing 

3D Print Settings for Hatchbox PLA on Ender 3

June 6, 2022August 12, 2022 Austin 0 Comments 3D Printing, Ender 3, PLA

These are my settings in Ultimaker Cura Quality: Go with a thick initial layer for adhesion, around 0.32. Then decrease

Read more

Looking for the Adventure Blog?

Don't worry, its still around - just where it's always been over at PointsUnknown.COM

Or the Motorcycle and Vanlife YouTube Channel?

Terms and Conditions

Your use of this website is subject to our Terms and Conditions.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Disclaimer

Points Unknown is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.

Privacy Policy

Your use of this website is subject to our Privacy Policy.

Copyright © 2023 Points Unknown – Tech Blog. All rights reserved.
Theme: ColorMag by ThemeGrill. Powered by WordPress.